Forum > Data Logging
Phidget 1048 Temperature() [Error 126]
erm0304:
I am trying to set up artisan 0.9.9 and am getting the following error after following the installation guidance: "The specified module could not be found @line 29087". Also ET, BT, and MET are all showing -1. Thank you in advance.
SusanJoM:
Pictures of your Configuration pages would help.
erm0304:
What other configurations would be helpful to see?
SusanJoM:
Okay, those first two look fine, and obviously the third is what we are trying to figure out.
Run through the Phidgets download just to be sure you have covered all the bases there, especially whether you wired the Phidget up right (right to left instead of left to right) and did whatever (I can't remember) Phidget told you to do to install it and close down the Phidget control panel....
https://www.hukyforum.com/index.php?action=downloads;cat=1
Right....I'm fishing, but I'm hoping we can catch something....
Wayneg1:
From the Phidget download you can run a test and it will let you know if it's connected. I would try that first and then move on to Artisan.
Navigation
[0] Message Index
[#] Next page
Go to full version