HUKY tear down with pictures

[Chert]

Tools needed:  Allen wrenches, metric 2, 2.5 and 3 mm;  wrench 7mm metric and 10 mm.

The front and back plates are held together with the 10 mm metric stainless bolts (4) and 2 7mm which also mount the bean exit chute.

Also 10mm bolts hold the motor assembly to the back plate.  That motor assembly is removed to access the back bearing best.

Also these pictures show the removal of the insulation shroud I have had in place.

[Chert]

Oh, and my heat shield suspended beneath the drum by wires.

[Chert]

And the last set

[trumz]

How many roasts on it before this teardown?

[Chert]

How many roasts on it before this teardown?

500.  And it retrospect I don't think it was needed.  I did have easier access to greasing the rear bearing though.

[trumz]

Good to know.  I will be doing the same In a few months.  I will be roasting 100kg for a summe café.