Artisan Documentation

[SusanJoM]

I thought Marko was going to announce this (as he did at HB and at the Artisan users list), but if you are looking for the Artisan downloads, they are now located here:

https://drive.google.com/folderview?id=0B4HTX5wS3NB2TFVid0h2TGxBWG8&usp=sharing

[JerryB]

I'm perplexed,
I am trying to understand something that I think was new in the version of Artisan 0.9.9 that I just installed.

In setting up my Artisan last week I saw something about connecting the ET before the BT or BT before the ET, can't remember which. Also I think there was a place in the setups section for switching this if you had set them up different? I can't seam to find the setup document that I was reading.  Does anyone know what I am talking about or where the document is that addresses this?

Cheers,
Jerry

[SusanJoM]

Artisan is going to read the TC you connect at 0 as BT and the TC you connect at 1 as ET.

However, if you connect them in reverse there is an opportunity in Artisan to simply reverse that, so that 0 would read out as ET and 1 as BT.

In the most recent version of Artisan that option is the last entry on the Roast Tab.

It was buried somewhere else in the most recent new versions;  I'm not sure what version it first appeared in; in any case,  I'm guessing I covered it in one of these documents:

https://drive.google.com/folderview?id=0B4HTX5wS3NB2TFVid0h2TGxBWG8&usp=sharing