Hey Everyone,
Finally received my new Huky this week!
I followed Phidget 1048 instructions and downloaded the installer for OSX. From there, I was able to open the Phidget window and observed my thermocouples showing the right temperature. Afterwards, I followed the instructions for downloading and fine tuning Artisan. I was ready to roast, but for some reason Artisan was not showing any temperature readings. Once I clicked "START", The BT, ET, and MET all read "-1". However, when I looked at my Phidget screen, I could see that my Thermocouples were reading 28-29 degrees C. So it seems I have downloaded Phidget, but Artisan does not synch with it.
Anyone experience this problem? I went back to Artisan to make sure it was configured to a "1048 Phidget" device", but even that didn't work. Any advice would be appreciated.